Emergency tarping
Buying time when the roof cannot be fixed today
Glen Cove, New York
Drip edge installation in Glen Cove
Drip edge is the L-shaped metal at the eaves and rakes that throws water clear of the fascia and into the gutter. Without it, water tracks back along the underside of the shingle edge and runs down the fascia board, which is the single most common reason fascia rots. It is inexpensive, it is required by most current codes, and it is routinely missing on older roofs — so it is worth checking whenever fascia or gutter work is being done.
What the job involves
- Assessment of existing edge detail at eaves and rakes
- Installation of correctly profiled drip edge
- Coordination with gutter position so water discharges correctly
- Replacement of fascia already damaged by the missing detail
Signs you need it
- Water staining or rot on the fascia board
- Water running behind the gutter rather than into it
- No visible metal at the roof edge above the gutter
Why roofs fail in Glen Cove and Nassau County
Glen Cove sits on a barrier-adjacent island where three things attack a roof at once. Salt air corrodes every metal component up there — flashing, fasteners, drip edge, vent collars — so the parts meant to outlast the shingles frequently do not, and most leaks here turn out to be metal failures rather than shingle failures. Nor'easters bring sustained wind with rain driven sideways, which gets under courses that would shed any amount of vertical water. Then winter adds ice damming at the eaves, where meltwater running down a warm roof refreezes over the cold overhang and backs up beneath the shingles. Housing stock across Nassau County runs older than the national average, with a lot of complex roof geometry, dormers and additions — and every junction is another place flashing has to work.
Glen Cove has a population of about 28,365, and the housing stock here sets the pattern for what fails first on a roof.
Questions about drip edge installation in Glen Cove
My roof has no drip edge. Is that a problem?
It is why the fascia rots. Water clings to the underside of the shingle edge and tracks back onto the timber instead of dropping into the gutter. Retrofitting it is cheap compared with replacing fascia repeatedly.
Can drip edge be added without redoing the roof?
At the eaves it can often be slid under the first shingle course. At the rakes it needs to go under the underlayment, which usually means lifting the edge courses. Both are localised jobs.
Other roofing work in Glen Cove
Attic leak tracing
Damp insulation, dry ceiling
Decking replacement
The sheathing under the shingles
Roof and attic ventilation
Airflow that stops condensation and ice dams
Slate roof repair
Natural slate, repaired not replaced
Wood shake and shingle repair
Cedar shake roofs
Describe what you are seeing
You will get a straight answer on whether Glen Cove needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (706) 696-1888